Use Your Tv; Switching On Your Tv And Putting It In Standby Mode; Adjusting Volume; Switching Channels - Philips 32PFL3508 User Manual

4 Use your TV

Switching on your TV and putting it in
Standby mode
39PFL3708
To Turn the TV On from Standby or Off to Standby
• Press (3 raised dots on the Rear panel or Front panel or the
Remote control).
Note
• Energy consumption contributes to air and water pollution. When the AC power cord
is plugged in, your TV consumes energy. Your TV has very low standby power
consumption.

Adjusting volume

39PFL3708
To decrease or increase volume
• Press VOL / (1 raised dot on the Rear panel or Front panel)
or press VOL + /
on the Remote control.
VOL : Volume Down
VOL : Volume Up
To mute or unmute sound
• Press on the remote control to mute the sound.
again or VOL + /
• Press
32PFL3508
32PFL3508
to recover the original sound.

Switching channels

39PFL3708
To select Channels by using CH
• Press CH (Down) / (Up - 1 raised dot on the Rear panel or
Front panel) or press CH + /
To select Channels by using the NUMBER buttons
Digital TV operation
• For Digital channels, press a number followed by a dot "•" and the
corresponding sub channel number.
– When selecting Digital channel 11.1
Be sure to press • before entering the subchannel number.
Analog/Cable TV operation
– When selecting cable or Analog channel 11
Press PREV.CH to return to the previously viewed channel.
Note
• To select the non-memorized channels, use the NUMBER buttons.
• No Signal will appear on the TV screen after the subchannel broadcast is over.
• Audio only program message will appear on the TV screen, when you receive only
sound signal.
* On the 46" & 50" TV's All CONTROL Keys are located on the Rear
(lower right) side of the unit as viewed from the Front.
17
32PFL3508
/ or CH + /
on the Remote control.
English