Making Wi-Fi Settings By Push Button Setup - Epson WF-7211 User Manual

User's Guide
6. Press the OK button to finish.
Note:
If you fail to connect, load paper, and then select Print connection report, and then press the OK button. The network
connection report of the printer will be printed.
Related Information
"Entering Characters" on page 16
&
"Checking the Network Connection Status" on page 25
&
"When You Cannot Make Network Settings" on page 124
&

Making Wi-Fi Settings by Push Button Setup

You can automatically set up a Wi-Fi network by pressing a button on the access point. If the following conditions
are met, you can set up by using this method.
❏ The access point is compatible with WPS (Wi-Fi Protected Setup).
❏ The current Wi-Fi connection was established by pressing a button on the access point.
Note:
If you cannot find the button or you are setting up using the software, see the documentation provided with the access point.
1. Select Wi-Fi on the home screen.
2. Select Push Button Setup(WPS).
3. Hold down the [WPS] button on the access point until the security light flashes.
If you do not know where the [WPS] button is, or there are no buttons on the access point, see the
documentation provided with your access point for details.
4. Press the OK button on the printer's control panel.
5. Press the OK button.
The screen automatically closes after a specific length of time if you do not press the OK button.
Note:
If connection fails, restart the access point, move it closer to the printer, and then try again. If it still does not work, print
a network connection report and check the solution.
Network Settings
21