Installing A Memory; Dimm Population Table - Gigabyte R260-R3C Service Manual

2-5-2 Installing a Memory

Before installing a memory module, make sure to turn off the computer and unplug the power
cord from the power outlet to prevent damage to the memory module.
Be sure to install DDR4 DIMMs on this motherboard.
Follow these instructions to install the Memory:
1. Insert the DIMM memory module vertically into the DIMM slot, and push it down.
2. Close the plastic clip at both edges of the DIMM slots to lock the DIMM module.
3. Reverse the installation steps when you want to remove the DIMM module.

2-5-3 DIMM Population Table

Type
RDIMM
RDIMM
RDIMM
RDIMM
LRDIMM
LRDIMM
3DS
NOTE!
DDR4 2400MHz is only available on Intel Xeon® E5-2600 V4 processor.
When only one DIMM is used, it must be populated in memory slot0 first.
Memory populated sequence must be followed with slot0/slot1/slot2.
System will not boot normally with incorrect populated sequence.
Slot Per Channel (SPC) and DIMM Per Channel (DPC)
Ranks Per
DIMM and
Data Width
1 Slot Per Channel
1DPC
SRx4
2133
SRx8
2133
DRx8 2133
DRx4
2133
QRx4 2133
8Rx4 2400
1
2
2
Speed (MT/s);
2 Slot Per Channel
1DPC
2133
2133
2133
2133
2133
2400
- 21 -
2DPC
1866
1866
1866
1866
2133
2400
Hardware Installation