Adjusting The Seat; Connecting The Battery Cables; Checking Tire Pressure - Cub Cadet XT1-LT42 Operator's Manual

Adjusting the Seat

To adjust the position of the seat, lift the seat adjustment lever
up. Slide the seat forward or rearward to the desired position;
then release the adjustment lever. Make sure seat is locked into
position before operating the tractor. See Figure 3-10.

Connecting the Battery Cables

CALIFORNIA PROPOSITION 65 WARNING
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals known
to the State of California to cause cancer and
reproductive harm. Wash hands after handling.
CAUTION:
connect the POSITIVE (Red) wire to its terminal first,
followed by the NEGATIVE (Black) wire.
For shipping reasons, both battery cables on your equipment may
have been left disconnected from the terminals at the factory. To
connect the battery cables, proceed as follows:
NOTE: The positive battery terminal is marked Pos. (+). The
negative battery terminal is marked Neg. (–).
NOTE: If the positive battery cable is already attached, skip
ahead to step 2.
12 S 3— A
ection SSembly
Figure 3-10
When attaching battery cables, always
& S -U
et p
1. Remove the plastic cover, if present, from the positive battery
terminal and attach the red cable to the positive battery
terminal (+) with the bolt and hex nut. See Figure 3-11.
2. Remove the plastic cover, if present, from the negative
battery terminal and attach the black cable to the negative
battery terminal (–) with the bolt and hex nut. See Figure
3-11.
3. Position the red rubber boot over the positive battery
!
terminal to help protect it from corrosion.
NOTE: If the battery is put into service after the date shown
on top/side of battery, charge the battery as instructed
in the Service section your Operator's Manual prior to
operating the tractor.

Checking Tire Pressure

WARNING!
maintained at all times. Refer to the tire sidewall for
proper pressure.
The tires on your tractor may be over-inflated for shipping
purposes. Reduce the tire pressure before operating the tractor.
Check the sidewall of tire for maximum p.s.i.
NOTE: Equal tire pressure is critical for level cutting deck
performance.
Figure 3-11
Equal tire pressure should be