Light Cover Install For Gdm-10F & Gdm-12F - True GDM-7-S-LD Installation Manual

Light Cover Installation for GDM-10F & GDM-12F
IMPORTANT
Before installing lamp cover turn cabinet on
and allow it to reach
temperature.
___________ STEP 1
Locate rubber gasket behind lamp holder
mounted to evaporator housing.
(See Image 1).
___________ STEP 2
Fit the bottom edge of the lamp cover into the
bottom groove of the rubber gasket and rotate
upwards while working the edges into the rest
of the rectangular groove. (See Images 2-3).
(slide fingers underneath top edges of rubber
gasket and push rubber over the top lip of the
lamp shield).
28
INSTALLATION / OPERATION INSTRUCTIONS
___________
Be sure lamp cover is seated properly in rub-
ber gasket.
NOTE
____________ If cabinet is turned off and
interior allowed to warm up lamp cover may
become loose and require reinstallation. Follow
directions above.
____________
1
............ www.truemfg.com ............
True Food Service Equipment, Inc.
STEP 3 ____________
Rubber
Gasket
Lamp
Holder
2
Lamp Cover
3
28