Slide Door Operation Instructions - True GDM-7-S-LD Installation Manual

True Food Service Equipment, Inc.
SLIDE DOORS
STEP 1
Before removing slide door do not use the side
latch. Tension on the door cord is needed to
execute these operation instructions. Doors can
not be removed unless placed in specific locations
stated in these instructions.
STEP 2
Two Door Units: Slide the front door so it is
centered on the cabinet. The door can not be
removed unless it is centered. See image 1 for
door channel openings and image 2 for
centering door.
Three Door Units: Slide the middle door to
the right side so the glass is centered with the left
edge of the right side door. See image 3.
1
(Two Door Units ONLY)
CENTERED DOOR
2
(Two Door Units ONLY)
CENTER DOOR
3
(Three Door Units ONLY)
9
INSTALLATION / OPERATION INSTRUCTIONS
Gasket fasten to door bottom assures door will
remain in track when unit is placed on uneven
surface.
STEP 3
After centering the door lift it up and tilt top of
door towards the back of the unit so the rollers are
out of the top channel. Swing the bottom of the
door out of the bottom channel. Then remove the
door and set it down. See image 4.
(TWO DOOR UNITS SKIP TO STEP 6)
STEP 4
Slide right door to the left so left edge lines up
with the left edge of TRUE Logo located above the
door. See image 5. Then lift door out of track
same way as image 4.
(Three Door Units ONLY)
STEP 5
Slide left door to the right so right edge lines up
with the end of the TRUE Logo located at the
top of the door frame. See image 6. Then lift
door out of track same way as image 4.
STEP 6
Remove door cord from roller bracket. The black
plastic tab holding the door cord slides out the
back. See images 7 & 8.
............ www.truemfg.com ............
4
TRUE Logo
5
TRUE Logo
6
Image 6 (Three Door Units ONLY)
7 8
STEP 7
Let the door cord slowly retract back into the
door side channel. The knot tied at the end of
the door cord will keep the cord from retracting
all the way back into the door channel. See
image 9.
Door Cord
9
P-Clip keeps cord
Knot
in-place (prevents
cord damage).
TO ADJUST SLIDE DOOR
STEP 1
After cabinet is installed in a final location and
correctly leveled check for any openings when the
slide doors are completely closed. If there are
any gaps/openings between the closed doors
and cabinet, the doors will need to be
adjusted.
STEP 2
Using a 7/16" wrench or adjustable wrench and
1/8" allen wrench loosen roller and move
along slotted hole. After adjustment has been
made tighten the
roller into place.
See image 10.
10
9