Dirt Devil MATRIXX M7118 Operating Manual page 30

2 Assembly
4
5
6
30
3. Insert the handle into the upper end of the telescopic
tube (Fig. 4) until you feel and hear the click lock lock in-
to place.
NOTE:
When connecting the two parts, you might need to twist
them in opposite directions until the you hear and feel the
click lock lock into place.
4. By gently pulling, check whether the handle and tele-
scopic tube are securely fastened together.
NOTE:
If you then want to release the two elements from one
another, all you have to do is press the release button on
the telescopic tube (Fig. 4/enlarged view) and then pull
the handle out of the tube.
5. Insert the floor nozzle into the bottom end of the tele-
scopic tube (Fig. 5) until you feel and hear the click lock
of the floor nozzle click into place.
NOTE:
When connecting the two parts, you might need to twist
them in opposite directions until the you hear and feel the
click lock lock into place.
6. By gently pulling, check whether the telescopic tube
and floor nozzle are securely fastened together.
NOTE:
If you then want to release the two elements from one
another, all you have to do is press the release button on
the floor nozzle (Fig. 5/enlarged view) and then pull the
tube out of the floor nozzle.
7. Adjust the length of the telescopic tube. Press down the
release latch on the tube to do this (Fig. 6). Then extend
the telescopic tube to the desired length. Let go of the
release catch while pulling until it locks in place. You will
hear a distinct click.
Your vacuum cleaner is now ready for use.