Table of Contents
Advertisement
DA1500 USA 1langue:pdf print
Important : Do not use sharp or abrasive cleaning agents or objects to
clean soleplate or other parts of the iron.
Do not use any cleaning or descaling products.
Never hold the iron under a running tap.
Always empty the water tank when you have finished ironing.
Storing your iron
Turn steam switch to off position. Unplug iron from electrical outlet.
Make sure the iron is cold before storing it.
IMPORTANT Do not wind the cord around the hot soleplate.
Never store your iron placed down onto the soleplate.
Problems
and possible causes
Your iron produces little or no steam
• The temperature selected is too low.
• The steam control is set on OFF.
• There is no water in the tank.
Water is dripping from the holes in the soleplate
• You have been using the burst of
steam button too often.
• Steam is used before the iron is
hot enough.
• The iron is stored with water in the
tank.
• The problem persists.
22/09/08
9:54
NO
10 min
Solutions
Set the temperature control to •••
Switch the steam control to ON.
Fill the water tank.
Wait a few seconds between each burst.
Set the thermostat within the
colored steam zone and wait until
the iron is hot (approx. 2 min.)
Empty the tank before storing the
iron and set the steam control to OFF.
Take your iron to an Approved
Service Center.
7
Page 7
Advertisement
Table of Contents
