Table of Contents
Advertisement
Replacing the Memory Module
You need a small Phillips screwdriver to replace
Tools
the memory module.
Locating Components
Preventing static electricity discharge
The components inside your notebook are extremely sensitive
to static electricity, also known as electrostatic discharge (ESD).
ESD can permanently damage electrostatic discharge-sensitive
components in your notebook.
To avoid exposure to dangerous electrical
voltages and moving parts, turn off your
notebook and unplug the AC adapter, modem
Warning
cable, and network cable before replacing a
component.
Before working with notebook components, follow these
guidelines:
•
Avoid static-causing surfaces such as carpeted floors,
plastic, and packing foam.
•
Remove components from their antistatic bags only when
you are ready to use them. Do not lay components on the
outside of antistatic bags because only the inside of the
bags provide electrostatic protection.
•
Always hold components by their edges. Avoid touching
the edge connectors. Never slide components over any
surface.
•
Wear a grounding wrist strap (available at most electronics
stores) and attach it to a bare metal part of your workbench
or other grounded connection.
•
Touch a bare metal surface on your workbench or other
grounded object.
Replacing the memory module
To replace the memory module:
1 Follow the guidelines under "Preventing static
electricity discharge."
2 Turn off your notebook.
3 Disconnect your notebook from the optional port
replicator.
Technical Support
See the label on the bottom of the notebook for Customer
Care Information. See your hardware guide for important
safety, regulatory, and legal information.
4 Disconnect the AC adapter, modem cable, and
5 Disconnect all peripheral devices connected to your
6 Turn your notebook over so the bottom is facing up,
7 With a small Phillips screwdriver, remove the
Memory
bay
8 Loosen the six memory bay screws (these screws
www.gateway.com
Replacing the Memory Module
network cable, if connected to your notebook.
notebook and remove any PC Cards.
then remove the main and optional secondary
batteries. For more information, see "Changing
Batteries" in your online hardware guide.
keyboard screw and put it in a safe place.
The screw hole is marked with a K.
Tips
cannot be removed), then remove the memory bay
cover.
© 2006 Gateway, Inc. All rights reserved. Gateway and
eMachines are trademarks or registered trademarks of
Gateway, Inc. in the United States and other countries.
All other brands and product names are trademarks or
registered trademarks of their respective companies.
Screw
1
Advertisement
Table of Contents
