Assembly - Char-Broil 415.161209 Product Manual

ASSEMBLY

Cart legs, Lower cart legs, Front panel and Back brace.
1
Insert lower cart legs into cart legs, make sure the holes for tank exclusion wire face inside, and the holes on lower cart
legs are aligned to the lower holes on cart legs. Position leg assemblies as shown below. Attach front panel and back
brace to legs using eight 1/4''-20x2'' carriage bolts and four 1/4''-20 tee knobs. Do not fully tighten all tee knobs until
step6.
Cart Leg
Back Brace
Tank support bracket and Wheels
2
Turn assembly upside-down. Insert axle bolts into wheels.
Facing the back, position tank support bracket between left legs. Insert axle bolt through leg and bracket and secure with
hitch pins.
Hitch Pin
Axle Bolt
Qty.2
Holes for tank exclusion wire
face inside
Qty.2
"Cone" side
of wheel
against leg.
Front Panel
Leg Extender
Wheel
Tank support
Tee Knob
1/4''-20x2''
Carriage Bolt
Qty.8
bracket Wheel
1/4''-20
Qty.8
Align holes
Axle bolt
17