Replacing Table Height Chain - Grizzly G0889 Owner's Manual

Replacing Table
Height Chain
The table height chain transfers movement from
the elevation handwheel to the leadscrews that
control cutterhead height. Replace the chain drive
if the chain stretches over time or breaks.
Tools Needed
Needle Nose Pliers ............................................ 1
Hex Wrench 6mm .............................................. 1
To replace table height chain:
1.
DISCONNECT MACHINE FROM POWER!
2.
Gently tilt machine onto its side to expose
table height chain (see
sprockets.
Figure 48. Table height chain.
-42-
Qty
Figure 48) and
Cotter Pin
3. Locate chain connection clasp and remove
cotter pin to disconnect chain (see Figure 48).
4. Clean and lubricate new chain and leadscrew
sprockets (refer to Headstock Height Chain
on Page 33 for detailed instructions).
5.
Install chain around sprockets, and connect
chain with cotter pin.
Model G0889/G0889Z (Mfd. Since 12/18)