Cleaning Feed Rollers - Grizzly G0889 Owner's Manual

Cleaning Feed
Rollers
The feed rollers rotate in bushing blocks that are
spring loaded. The feed rollers ride up on the
board so that the roller pressure is maintained.
If chips or sawdust build up between the bracket
and bushing block (see Figure 39), the amount
of roller vertical travel will be reduced, potentially
causing improper feeding of workpiece through
the machine.
Bracket
Figure 39. Sawdust can get trapped between the
bushing block and the bracket.
Model G0889/G0889Z (Mfd. Since 12/18)
Bushing
Block
Periodically check and clean chips and sawdust
from between the bushing blocks and brackets.
Items Needed
4'' Tall Block of Wood ........................................ 1
To clean feed rollers:
1. DISCONNECT MACHINE FROM POWER!
2.
Place a 4'' tall block of wood between one
feed roller and planer table. Ensure block of
wood is not under cutterhead.
3. Lower cutterhead assembly just enough so
roller is pushed up against spring and pres-
sure is off of two brackets.
4. Remove any trapped material from between
roller assembly and bracket.
Qty
-35-