Kyocera 1102RV3AS0 Operation Manual page 117

Troubleshooting > Troubleshooting
Symptom
Printed images are fuzzy.
Printed images are skewed.
Irregular horizontal lines
appear in the image.
The altitude is 1000 m or
higher and irregular
horizontal white lines appear
in the image.
The altitude is 1000 m or
higher and dots appear in
the image.
Dirt on the top edge or back
of the paper.
Checkpoints
Is the device used in an environment
with high humidity or where the
temperature or humidity changes
suddenly?
—
Is the paper loaded correctly?
—
—
—
Is the interior of the machine dirty?
—
Corrective Actions
Use in an environment that has suitable
humidity.
Select [Adjust print quality] in the
Maintenance menu, and select
[Refresh] in [Drum refresh].
Check the position of the paper width
guides.
Select [Adjust print quality] in the
Maintenance menu and set a higher value for
"Drum charge setting". Increase the
adjustment value 1 level at a time from the
current value. If there is no improvement after
the value is increased by 1 level, increase by
1 level again. If there is still no improvement,
return the setting to the original value.
Select [Adjust print quality] in the
Maintenance menu, and set "Altitude
adjustment" to one altitude level higher
than the current setting.
Select [Adjust print quality] in the
Maintenance menu, and set "Altitude
adjustment" to one altitude level higher
than the current setting.
Clean the interior of the machine.
Clean the charger inside of the machine.
6-14
Reference
Page
—
page 6-10
page 3-4
page 6-10
page 6-10
page 6-10
page 6-2
page 6-2