Connecting Cables To The Computer - Fujitsu P24W-7 LED Operating Manual

Getting started
If you use a DisplayPort cable, you must switch the 0 W switch to the BASIC position. If
you use a VGA, HDMI or DVI Dual Link data cable, you can switch the 0 W switch to the
ECO "0" position to activate the 0 W energy saving mode when the PC is switched off.
The monitor automatically detects the input (VGA, HDMI, DVI, DisplayPort)
when only one signal source is connected.
Note that the 0 W function cannot be guaranteed when using any
kind of signal cable adaptor.
► Insert one connector of the audio line in the AUDIO IN (8) socket on the
monitor and make sure it is properly engaged.
► Plug the power cable supplied into the power connector of the monitor.
► Plug the supplied USB 3.0 cable into the USB 3.0 (Upstream) socket (10) and the
other end of the cable into a USB 3.0 socket on the computer.
Connect the USB keyboard and USB mouse directly to the PC, as the USB connector
socket of the monitor is switched off in energy-saving mode.
A lock (Security Lock) can be mounted in the security slot to protect the monitor
against theft. A Security lock is not supplied with the monitor.

Connecting cables to the computer

Information on the computer connections and interfaces is contained in the
operating manual for your computer.
► Connect the data cable to the (active) monitor port on the computer and secure
the plug-in connection by tightening the safety screws.
► Insert the other plug of the audio cable in the audio output of the computer.
► Plug the power connector of the monitor into a properly grounded mains outlet.
► Plug the power connector of the computer into a properly grounded mains outlet.
If your computer has two monitor ports ("onboard" screen controller and separate
graphics card), the monitor port for the separate graphics card is active as standard.
18 Fujitsu