Battery & Charger - Snapper XD SXD19PWM82 Owner's Manual

BATTERY & CHARGER
CHARGING PROCEDURE
NOTE: The battery is not shipped fully charged. It is recommended to fully charge before first use to ensure that maximum
run time can be achieved. This lithium-ion battery will not develop a memory and may be charged at any time.
Low voltage charging:
If the battery has been stored with little to no charge for a long period of time, the charger will go into recovery mode, which
will take 20 hrs to fully charge the battery. This will enhance the life of the battery. Once it is fully charged, the next charge
will return to standard charging.
1. Plug the charger into an AC power outlet.
2. Insert the battery pack into the charger.
This is a diagnostic charger. The Charger LED Lights will illuminate in specific order to communicate the current battery
status. They are as follows:
False defect note:
When the battery is inserted into the charger and the status LED blinks RED, remove the battery from the charger for
1 minute, then reinsert. If the status LED blinks GREEN, then the battery is properly charging. If the status LED is still
blinking RED, remove the battery and unplug the charger for 1 minute. After 1 minute, plug in the charger and reinsert the
battery. If the status LED blinks GREEN, then the battery is properly charging. If the status LED is still blinking RED, the
battery is defective and needs to be replaced.
Fully Charging
Charged
LED STATUS
Solid Green
Blinking Green
Solid Red
Blinking Red
19
Over Charging
Temperature
DESCRIPTION
Fully Charged
Charging
Over Temperature
Charging Fault
Fault