Custom Program; Steam Functions - LG DLGX3876V Owner's Manual

CUSTOM PROGRAM

If you have a special combination of settings
that you use frequently, you can save these
settings as a CUSTOM PROGRAM.
* To Save a Custom Program:
Turn on the dryer and turn the cycle selector
1
knob to select the desired cycle.
Use the cycle setting buttons to adjust the
2
settings for that cycle.
Press the cycle option button(s) for the option
3
you would like to add. A confirmation message
will be shown in the display.
Press and hold the CUSTOM PROGRAM button
4
for 3 seconds.

STEAM FUNCTIONS

To Fill the Steam Feeder
Pull out the drawer.
1
Lift out the steam feeder.
2
IMPORTANT NOTES ABOUT STEAM CYCLES
E3 ERROR
WATER SUPPLY ERROR.
FILL STEAM FEEDER WITH FILTERED
WATER.SEE OWNER`S MANUAL.
(LGUS)1-800-243-0000
(LGCANADA)1-888-542-2623
• O nly use water. Do not fill the steam feeder with
foreign substances, rinse agents, or detergents.
• Before moving the dryer, make sure the steam feeder is empty.
• Do not use distilled water; the water level sensor in the steam generator will not work.
• Be careful to put the Steam Feeder otherwise water will be overflow.
• Wipe up any spilled water around the Steam Feeder and the drawer before starting the dryer.
wWARNING:
• D o not fill the steam feeder with liquids such as gasoline, dry-cleaning solvents, or other flammable or explosive
substances. They give off vapors that could explode.
• Do not fill the steam feeder with hot water (over 86°F/30°C).
• Do not drink water from the steam feeder.
NOTE: You may only save one custom
program at a time. Pressing and holding the
CUSTOM PROGRAM button will overwrite
any previously saved custom program.
To Recall a Custom Program:
Turn on the dryer.
1
2 Press the CUSTOM PROGRAM button.
Press the START/PAUSE button to start
3
the cycle.
Fill the steam feeder to MAX with water.
3
Steam
Drawer
Feeder
Place the steam feeder in the drawer; then
4
push in the drawer until it clicks into place.
Before using a Steam Cycle, the steam feeder must be filled with water up to
the MAX line. If not, an Error message or ADD WATER will be displayed. Make
sure that the steam feeder is filled with water and the drawer is completely
closed. Turn the dryer off then restart the Steam Cycle.
Water
ONLY
35