Troubleshooting; Checking Error Messages - LG WT4801CW Owner's Manual

28

TROUBLESHOOTING

TROUBLESHOOTING

Checking error messages

If the following message appears on the display, check the following and take the appropriate corrective action.
Message
Water in the washer Drain hose is bent, pinched, or clogged.
y
drains slowly or not
at all, or the display
shows:
Washer fills with water Water supply taps are not open fully.
y
slowly or not at all, or Water line hoses are kinked, pinched, or
y
the display shows:
bent.
Water inlet filters are clogged.
y
Water pressure to tap or house is too low.
y
Washer will not turn on Power cord is not properly plugged in.
y
House fuse is blown, circuit breaker has
y
tripped, or power outage has occurred.
The display shows: The lid is not closed properly.
The display shows: Lid lock switch error
y
The display shows: Water level is too high due to a faulty water
y
valve.
The display shows: Clutch error
y
Possible Causes Solutions
Make sure the drain hose is free of clogs, kinks, etc.,
y
and is not pinched behind or under the washer.
Make sure that the water taps are open fully.
y
Make sure the hoses are not kinked or pinched. Be
careful when moving the washer.
Clean the inlet filters. See the Care and Cleaning
y
section.
Check another faucet in the house to make sure that
y
household water pressure is adequate.
Make sure that the plug is plugged securely into a
y
grounded, 3-prong, 120-VAC, 60-Hz. outlet.
Reset circuit breaker or replace fuse. Do not increase
y
fuse capacity. If the problem is a circuit overload, have
it corrected by a qualified electrician.
Make sure that the lid is closed properly and press the
y
START/PAUSE button. After starting a cycle, it may
take a few moments before the drum begins to turn or
spin. The washer will not spin unless the lid is locked
(LID LOCK light will turn on).
If the lid is closed and locked and the open lid error
y
message is displayed, call for service.
If you press the START button while the lid is open, dE
y
error message will be displayed.
Make sure that the lid is closed properly and press the
y
START/PAUSE button. The washer will not spin unless
the lid is locked (LID LOCK light will turn on).
If the lid is closed and the lid lock error message is
y
displayed, call for service.
Close the water taps, unplug the washer, and call for
y
service.
Unplug the washer, and call for service.
y