Table of Contents
Advertisement
Installation
Installation Precautions
Provide proper ventilation for this projector.
•
The projector is equipped with ventilation holes(intake) on
the bottom and ventilation holes(exhaust) on the front. Do
not block or place anything near these holes. Internal heat
build-up may occur, causing picture degradation or dam-
age to the projector.
•
Never push the projector or spill any kind of liquid into the
projector.
Place this projector in adequate temperature and humidity conditions.
•
Install this projector only in a location where adequate temperature and humidity is available. (refer page 52)
Don't place the projector where it can be covered with excessive dust.
•
This may cause overheating of the projector.
Do not obstruct the slots and openings of the projector. This may cause overheating and cause a fire hazard.
This projector is manufactured using high-precision technology. You may, however, see tiny black points and/or bright
points (red, blue or green) that continuously appear on the projector Screen. This is a normal result of the manufacturing
process and does not indicate a malfunction.
The remote control may not work when a lamp equipped with electronic ballast or a three-wavelength lamp is installed.
Replace those lamps with international standard products to use the remote control normally.
•
Do not place the projector on a carpet, rug or other similar
surface. It may prevent a adequate ventilation of the pro-
jector bottom. This projector should be placed in the plain
floor or mounted to the ceiling.
•
Leave an adequate distance (30 cm or more) around the
projector.
Installation
11
Advertisement
Table of Contents
