Panasonic KX-TG153CSK Operating Instructions Manual page 47

4
MbN: "Phonebook" a MSELECTN
5
MbN: Select the phonebook entry. a MSAVEN
R "Baby monitor" will be displayed.
Note:
R If you edit a phonebook entry which is assigned
for monitoring, the edited entry does not transfer
to the monitor.
n By entering phone numbers:
1
MMENUN#268
2
MbN: "On" a MSELECTN
3
MbN: Select "Outgoing call" to monitor
from an outside line. a MEDITN a MADDN
4
MbN: "Manual" a MSELECTN
5
Enter the desired name. a MOKN
6
Enter the desired number. a MOKN a
MSELECTN
R "Baby monitor" will be displayed.
Note:
R The registered name/number is displayed.
Turning off the baby monitor
The monitored handset cannot be used while baby
monitor is set to "On".
Handset
1
Press MMENUN on the handset being
monitored.
2
MbN: "On/Off" a MSELECTN
3
MbN: "Off" a MSELECTN a MOFFN
Editing an outside monitoring number
Handset
1
Press MMENUN on the handset being
monitored.
2
MbN: "On/Off" a MSELECTN
3
MbN: "On" a MSELECTN
4
MbN: Select the outside line. a MEDITN
5
MMENUN a MbN: "Edit" a MSELECTN
6
Edit the name if necessary. a MOKN
7
Edit the phone number if necessary. a MOKN
a MSELECTN
For assistance, visit www.panasonic.ca/english/support
TG153CSK(en)_0422_ver021.pdf 47
Erasing an outside monitoring number
Handset
1
Press MMENUN on the handset being
monitored.
2
MbN: "On/Off" a MSELECTN
3
MbN: "On" a MSELECTN
4
MbN: Select the outside line. a MEDITN
5
MMENUN a MbN: "Erase" a MSELECTN
6
MbN: "Yes" a MSELECTN a MOFFN
Baby monitor sensitivity
You can adjust the sensitivity of the baby monitor.
Increase or decrease the sensitivity to adjust the
sound level needed to trigger the baby monitor
feature.
R This feature cannot be set during a monitoring
call.
Handset
1
Press MMENUN on the handset being
monitored.
2
MbN: "Sensitivity level" a MSELECTN
3
MbN: Select the desired setting. a MSAVEN
a MOFFN
Answering the baby monitor
Handset / Base unit
n When monitoring with a unit:
Handset: Press M N to answer a call.
Base unit: Press M N to answer a call.
If you want to respond from the monitoring unit,
press MMUTEN.
R The monitoring unit will answer calls
automatically when the auto intercom feature
is set to "On" (page 27).
Note:
R If you receive an outside call when
communicating with the monitored handset,
the interrupt tone sounds.
– To answer the call with the handset, press
MOFFN, then press M
– To answer the call with the base unit, press
*1
M N 3 times.
*1 If MMUTEN is pressed, press MZN 2 times.
2016/04/22
Programming
N.
47
14:54:43