Table of Contents
Advertisement
Set up EasyLink (HDMI-CEC
control)
This SoundStage supports Philips EasyLink, which
uses the HDMI-CEC (Consumer Electronics
Control) protocol. EasyLink-compliant devices
that are connected through HDMI can be
controlled by a single remote control.
Note
•
Depending on the manufacturer, HDMI-CEC is known
by many names. For information on your device, see
the user manual of the device.
•
Philips does not guarantee 100% interoperability with
all HDMI-CEC devices.
Before you start
•
Connect your SoundStage to the HDMI-CEC
compliant device through HDMI connection.
•
Make the necessary connections described
in the quick start guide, and then switch
the TV to the correct source for your
SoundStage.
Enable EasyLink
1
Press .
2
Select [Setup], and then press OK.
3
Select [EasyLink] > [EasyLink] > [On] .
4
On your TV and other connected devices,
turn on HDMI-CEC control. For details, see
the user manual of the TV or other devices.
•
On your TV, set the audio output to
'Amplifier' (instead of TV speakers).
For details, see the TV user manual.
EasyLink controls
With EasyLink, you can control your SoundStage,
TV, and other connected HDMI-CEC compliant
devices with a single remote control.
[One Touch Play] (One-touch play): When
•
a video disc is in the disc compartment,
press
to wake up the TV from standby,
and then play a disc.
10
EN
[One Touch Standby] (One-touch
•
standby): If one-touch standby is enabled,
your SoundStage can switch to standby
with the remote control of the TV or other
HDMI-CEC devices.
[System Audio Control] (System
•
audio control): If system audio control
is enabled, the audio of the connected
device is output through your SoundStage
automatically when you play the device.
[Audio Input Mapping] (Audio input
•
mapping): If system audio control does not
work, map the connected device to the
correct audio input connector on your
SoundStage (see 'Set up the audio' on
page 10).
Note
•
To change the EasyLink control settings, press
[Setup] > [EasyLink].
Set up the audio
If you cannot hear the audio output of a
connected device through your SoundStage, do
the following:
•
Check that you have enabled EasyLink on
all the devices (see 'Enable EasyLink' on
page 10), and
•
on your TV, set the audio output to
"Amplifier" (instead of TV speakers). For
details, see the TV user manual, and
•
setup the EasyLink audio control.
1
Press .
2
Select [Setup], and then press OK.
3
Select [EasyLink] > [System Audio
Control] > [On].
•
To play the audio from the TV
speakers, select [Off], and skip the
following steps.
4
Select [EasyLink] > [Audio Input
Mapping].
, select
Advertisement
Table of Contents
