Option 2: Connect audio through a
digital coaxial cable
Best quality audio
1
Using a coaxial cable, connect the
COAXIAL IN connector on your
SoundStage to the COAXIAL/DIGITAL
OUT connector on the TV or other
device.
•
The digital coaxial connector might be
labeled DIGITAL AUDIO OUT.
Option 3: Connect audio through
analog audio cables
Basic quality audio
1
Using an analog cable, connect the AUX
IN connector on your SoundStage to the
AUDIO OUT connectors on the TV or
other device.
10
EN
Set up EasyLink (HDMI-CEC
control)
This SoundStage supports Philips EasyLink,
which uses the HDMI-CEC (Consumer
Electronics Control) protocol. EasyLink-
compliant devices that are connected through
HDMI can be controlled by a single remote
control.
•
•
Before you start
•
•
VCR
Enable EasyLink
1
2
3
4
EasyLink controls
With EasyLink, you can control your
SoundStage, TV, and other connected HDMI-
CEC compliant devices with a single remote
control.
Note
Depending on the manufacturer, HDMI-CEC is known
by many names. For information on your device, see
the user manual of the device.
Philips does not guarantee 100% interoperability with
all HDMI-CEC devices.
Connect your SoundStage to the HDMI-
CEC compliant device through HDMI
connection.
Make the necessary connections described
in the quick start guide, and then switch
the TV to the correct source for your
SoundStage.
Press .
Select [Setup], and then press OK.
Select [EasyLink] > [EasyLink] > [On] .
On your TV and other connected devices,
turn on HDMI-CEC control. For details, see
the user manual of the TV or other devices.
•
On your TV, set the audio output to
'Amplifier' (instead of TV speakers).
For details, see the TV user manual.