Prepare The Hood - Broan BCDF Series Installation Use And Care Manual

Prepare the Hood

1 ] If present, remove all protective polyfilm from the hood and/or parts.
2 ] Using the finger cup (BCDF Series) or the tab (BCSEK Series), remove the grease filters
from the hood by pushing down
B
3 ] Remove the EZ1 brackets from inside the hood by cutting off the tie wrap. Remove both
screws holding damper assembly to hood. Remove parts bag (captured behind the damper
assembly). Remove damper assembly from inside the hood and keep the screws for further
use.
EZ1
BRACKETS
4 ] Remove the wiring cover (shaded part on illustration below) by sliding it out from the hood
and set it aside.

and tilting filter(s) out
C

.
SCR EWS
DAMPER
ASSEMBLY
9