Range Hood Care; Cleaning; Replacing A Led Lamp; Accesories - Samsung NK36N7000US Installation Instruction Manual

Range Hood Care

Cleaning

IMPORTANT: Clean the hood and grease filters frequently according to
the following instructions. Replace baffle filters before operating the hood.
Exterior surfaces:
•
To avoid damage to the exterior surface, do not use steel wool or
soap-filled scouring pads.
• Always wipe dry to avoid water marks.
Cleaning method:
• Liquid detergent soap and water or all-purpose cleanser.
• Wipe with damp soft cloth or nonabrasive sponge, and then rinse with
clean water and wipe dry.
• Do not use cleaning agents containing bleach
Stainless steel baffle filter:
1. Remove the filter by pulling the spring release handle, and then
pulling down the filter.
A. Spring release handle
2. Wash the stainless steel baffle filter as needed in a dishwasher or hot
detergent solution.
3. To reinstall the filter, first make sure the spring release handle is
toward the front. Insert the stainless steel filter into the upper track.
4. Push in the spring release handle.
5. Push up on the stainless steel filter, and then release the handle to
latch it into place.
WARNING
When removing the filter, please hold it with both hands to make sure it
does not fall.
Replacing the LED lamps
The LED lights are replaceable by a service technician only.
See the support contact information in the Warranty section.
Accessories
NOTE
When used in recirculation mode, To Reduce the Risk of Fire and Shock
use only conversion kit Models:
Recirculating kit: NK-AF030FNB/AA
Charcoal filter replacement: NK-AR050FNB/AA
Recirculating kit are not included with the hood.
They must be ordered from your supplier or Samsung service center.
Order the needed kit specifying your hood model and width size.
Recirculating kit
If it is not possible to vent cooking fumes and vapors to the outside, the
range hood can be used in the non-vented (recirculating) version, using a
charcoal filter. Recirculation Kit is available from the dealer or an authorized
parts distributor.
G
D
F
A
A. Ceiling
B. Vent cover
C. Soffit
D. 6" (15.2 cm) vent
E. Range hood
NOTE
12" (30.5 cm) high cabinets without a soffit may allow the 6" (15.2 cm)
vent and vent cover to be seen.
To replace charcoal filter:
NOTE
The maximum BTUs if you use carbon filter is 40 000. If you use the hood
with the carbon filters on and it does not decrease the BTUs the engine
can fail or generate an unsafe act.
1. Cover the grille that covers the blower motor with the charcoal filter
so that the slots on the filter correspond to the pins on the sides of
the motor grille.
2. Turn the charcoal filter clockwise to lock it.
3. Repeat steps 1-2 on the other filter.
A
G
B
F
H
E
F. Cabinet
G. Wall
H. 17" (43.2 cm) min.
vent cover height
C
A
B
A. Charcoal filter
B. Pins
C. Blower motor
A
B
C
D
E
English 13