Table of Contents
Advertisement
5.5 Adaptation to different types of
gas
If other types of gas are to be used, the
nozzles must be replaced and the primary
air must be adjusted. In order to replace the
nozzles and adjust the burners, the hob top
must be removed.
In order to be able to replace the
nozzles, the appliance must be
removed from the built-in unit.
Removing the hob top
1. Pull the knobs and the knob bezels
(where present) upwards to remove
them.
Between knob and knob bezel
(depending on the model) there is
a spring that is not shown in the
figure.
92
Installation
2. Remove the grids from the hob.
3. Remove the flame-spreader crowns and
relative burner caps.
Advertisement
Table of Contents
