Important Safety Instructions; Installation - Tripp Lite Protect It! TLP606DMUSB Owner's Manual

Important Safety Instructions

SAVE THESE INSTRUCTIONS
CAUTION! DO NOT connect to an ungrounded outlet. DO NOT use with 2-wire extension
cords or adapters. This surge protector is designed for indoor use only. Install the surge
protector away from heat-emitting appliances such as radiators or heat registers. Do
not install where excessive moisture is present. Do not plug extension cords into it.
Never install electrical, telephone, network or coaxial wiring during a lightning storm. Do
not drill into any part of the housing or open the housing for any reason. There are no
user-serviceable parts inside.
• Use of this equipment in life support applications where failure of this equipment can
reasonably be expected to cause the failure of the life support equipment or to significantly
affect its safety or effectiveness is not recommended. Do not use this equipment in the
presence of a flammable anesthetic mixture with air, oxygen or nitrous oxide.

Installation

Mount Your Surge Protector
(Optional Installation, TLP606USB Only): If desired, mount your surge protector on a wall
or other sturdy, vertical surface. However, you must mount the surge protector prior to
connecting your equipment. Place a sheet of paper over the surge protector's mounting
holes and mark their centers with a push pin. Next, place this template over the desired
area and mark with the push pins. Install screws (user supplied) into the marks until ¼ in.
(0.6 cm) of the screw heads are exposed. Mount the surge protector over the screw heads
and slide into place.
(Installation, TLP606DMUSB
Only): This protector features a
built-in clamping system for
attaching the unit to desks,
tables and work benches. To
install, loosen the two mounting
clamps, then slide the protector
firmly onto the edge of an
appropriate surface. Retighten
the mounting clamps.
Connect Your Surge Protector to
the AC Power Line: Plug the surge
protector's power cord into a
standard, 3-wire grounded 120V AC
outlet.
Turn Your Surge Protector ON:
Press the surge protector's power
switch to "ON" or "RESET"
(depending on model). Select
models feature an illuminated switch.
18-08-295-9332C8.indb 2
Installation, TLP606DMUSB Only
2
9/10/2018 10:27:55 AM