Table of Contents
Advertisement
Important Safety Instructions
SAVE THESE INSTRUCTIONS
CAUTION! DO NOT connect to an ungrounded outlet. DO NOT use with 2-wire
extension cords or adapters. This surge suppressor is designed for indoor use
only. Install the surge suppressor away from heat-emitting appliances such as
radiators or heat registers. Do not install where excessive moisture is present.
Do not plug extension cords into it. Never install electrical, telephone, network
or coaxial wiring during a lightning storm. Do not drill into any part of the
housing or open the housing for any reason. There are no user-serviceable
parts inside.
The surge suppressor features an internal protection that will disconnect
the surge-protective component at the end of its useful life but will maintain
power to the load—now unprotected.
Features
"Master" Outlet: Allows one "Master" device to control power for up to
eight peripheral devices (model dependent). "Master" device can be any 15
watt or higher device.
"Power Save" Outlets: In GREEN power-saving mode, these outlets have
power cut by the "Master" device when idle or turned off. These outlets
are recommended for intermittent-use devices such as monitors, printers,
scanners, lamps, DVD players, gaming consoles, amplifiers and speaker
systems.
"Always On" Outlets: Provide continuous power even in GREEN power-
saving mode. These outlets are recommended for critical devices such as
modems, routers, external drives, cordless phones, fax machines, DVRs
(TiVo
), cable and satellite boxes.
®
User-Adjustable Wattage Control Switch: Found on the back panel of the
surge suppressor, this switch allows both higher-wattage (25W) and lower-
wattage (15W) devices to be designated as the "Master" device. PCs, laptops,
Netbooks or any 15W device can control the GREEN power-saving mode.
Auto/Manual Switch: Allows the user to choose between GREEN power-
saving mode (Auto) or standard protection (Manual). All outlets are protected
from surges in accordance with the model's joule rating in either mode.
Diagnostic LEDs: "Grounded" (Red) LED assures wall outlet is grounded
and surge protection can function properly. "Protected" (Green) LED assures
that surge protection is present. If this green LED ever goes out, Tripp Lite will
replace your surge suppressor under warranty at no charge.
Status LEDs: "Master" , "Power Save" and "Always On" (all Red) LEDs light
when AC power is present.
RJ11 Telephone Jack (select models): Connect phone cables from the wall
jack through the surge suppressor (RJ11 jacks) to the device to be protected.
2
Advertisement
Table of Contents
