Table of Contents
Advertisement
2
2. Move the upper basket to the lowest level to
reach the spray arm more easily.
3. To detach the spray arm (C) from the delivery
tube (A), turn the mounting element (B)
counterclockwise and pull the spray arm
downwards.
4. Wash the spray arm under running water. Use
a thin pointed tool, e.g. a toothpick, to remove
particles of soil from the holes. Run the water
through the holes to wash soil particles away
from the inside.
TROUBLESHOOTING
WARNING! Improper repair of the
appliance may pose a danger to the
safety of the user. Any repairs must be
performed by qualified personnel.
The majority of problems that may occur can
be solved without the need to contact an
Authorised Service Centre.
Problem and alarm code
You cannot activate the appli-
ance.
The programme does not start.
1
•
Make sure that the mains plug is connected to the mains sock-
et.
•
Make sure that there is no damaged fuse in the fuse box.
•
Make sure that the appliance door is closed.
•
If the delay start is set, cancel the setting or wait for the end of
the countdown.
•
The appliance recharges the resin inside the water softener.
The duration of the procedure is approximately 5 minutes.
5. To install the spray arm (C) back, insert the
mounting element (B) in the spray arm and fix it
in the delivery tube (A) by turning it clockwise.
Make sure that the mounting element locks into
place.
6. Install the cutlery drawer on the sliding rails and
block the stoppers.
Refer to the below table for information on possible
problems.
With some problems, the display shows an alarm
code.
Possible cause and solution
19
Advertisement
Table of Contents
