Table of Contents
Advertisement
Basic OSD menu - without input signals
connected
As there's no input signal to your projector, only the submenus of Settings under Basic
OSD menu - with input signals connected are available. Menu options that are not available
will become grayed out.
To access the OSD menu, press MENU on the projector or remote control.
•
Use the arrow keys (▲/▼/◄/►) on the projector or remote control to move through
the menu items.
•
Use OK to confirm the selected menu item.
To switch from the Basic OSD menu to the Advanced OSD menu, see
on page
32.
Menu
Language
Projector Position
Test Pattern
Auto Source
Menu Type
HDMI Format
Reset Lamp Timer
Reset All Settings
Information
Submenus and Descriptions
Sets the language for the On-Screen Display (OSD) menus.
The projector can be installed on a ceiling or behind a screen, or with
one or more mirrors. See
Enables this function to display the grid test pattern, which helps you
adjust the image size and focus so as to check if the projected image is
free of distortion.
Sets whether the projector searches automatically for input sources.
Select On to enable the projector to scan for input sources until it
acquires a signal. If the function is set to Off, the projector selects the
last used input source.
Switches to the Advanced OSD menu.
Selects an input source type for the HDMI signal. You can also manually
select the source type. The different source types carry different
standards for the brightness level.
HDMI Format is only available when the HDMI signal is selected.
Activates this function only after a new lamp is installed. When you select
Reset, a "Reset Successfully" message displays to notify that the lamp
time has been reset to "0".
Returns all settings to the factory preset values.
The following settings will still remain: Keystone, Language,
Projector Position, and Reset Lamp Timer.
Displays the following information about your projector.
•
Source: Displays the current signal source.
•
Picture Mode: Displays the current Picture Mode.
•
Resolution: Displays the native resolution of the input source.
•
Color System: Displays input system format.
•
Lamp Usage Time: Displays the number of hours the lamp has
been used.
•
3D Format: Displays the current 3D mode.
3D Format is only available when 3D Mode is enabled.
•
Firmware Version: Displays the firmware version of your projector.
Some information is given only when certain input sources are in use.
"Choosing a location" on page 16
"About the OSD Menus"
for details.
Menu Functions
37
Advertisement
Table of Contents
