Coffee Brewing; Dispensing Hot Water - Philips Saeco Xsmall HD8745/57 Operating Instructions Manual

COFFEE BREWING

Before brewing coff ee, make
sure that the green tempe-
rature light " " is steady on and that
the water tank and the coff ee hopper
are full.
Steady on
Leave the control dial on the
coff ee position " " during the
dispensing phase.
• Place 1 or 2 cups under the dispensing
spout.
• To brew coff ee, press and release:
the " " button for an espresso coff ee;
the "
• To dispense 1 cup of coff ee, press the
button once. To dispense 2 cups of coff ee,
press the button twice.
In this operating mode, the
machine automatically grin-
ds and doses the correct amount of
coff ee. Brewing two coff ees requires
two grinding cycles and two brewing
cycles, automatically carried out by
the machine; this option is indicated
by the "
" light being constantly on.
• After the prebrewing cycle, coff ee begins
to dispense out of the dispensing spout.
• Coffee brewing stops automatically
when the pre-programmed level is rea-
ched; however, it is possible to interrupt
coff ee brewing by pressing the button
initially pressed.
Steady on
The machine is adjusted to
brew a true Italian espresso
coffee. This feature may slightly
lengthen the brewing time, allowing
the intense flavor of the coffee to
develop fully.
• 11 •
" button for a long coff ee.

DISPENSING HOT WATER

Warning: Dispensing may be
preceded by short sprays of
hot water, and scalding is possible.
The hot water/steam wand may reach
high temperatures. Do not touch it
with bare hands; use the appropriate
handle only.
Steady on
• Before dispensing hot water, check
that the green temperature " " light
is steady on.
When the machine is ready, proceed as
follows:
• Place a container under the hot water /
steam wand (Pannarello, if supplied);
• Turn the control dial clockwise to set it
to the " " position.
• Fill the cup with hot water to the desi-
red level; to stop hot water dispensing,
turn control dial counter-clockwise
back to the " " position. The machine
returns to the normal operating mode.
Occasionally, after turning
the control dial, hot water
may not be dispensed and the " "
light may blink slowly. To obtain a
fl ow of hot water, simply wait until
the " " light stops blinking and re-
mains steady.