Table of Contents
Advertisement
Audio setup
Audio Setup
Speakers Volume
Speakers Delay
HDMI Audio
CD Upsampling
Audio Sync
1
Press
SETUP .
» [General Setup] menu is displayed.
2
Press
to select [Audio Setup] , then
press .
3
Select an option, then press OK .
4
Select a setting, then press OK .
•
To return to the previous menu,
press
BACK .
•
To exit the menu, press
Note
•
See the explanations of the above options in
the following pages.
[Speakers Volume]
Sets the volume level of each speaker to get
the ideal audio balance.
1) To start, press OK .
2) Select a speaker in the menu, then press
to adjust the volume level.
3) Press OK to conÀ rm and exit.
Note
•
The test tone is emitted from the speaker
which you adjust.
32
EN
[Speakers Delay]
Sets the delay time for the center and rear
speakers if they are placed closer to the
listening position, so that the sound output
from all speakers reach the listening position
at the same time.
1) To start, press OK .
2) Select a speaker in the menu, then press
3) Press OK to conÀ rm and exit.
•
[HDMI Audio]
Selects the HDMI audio setting when you
connect this Home Theater System and the
TV with a HDMI cable.
•
SETUP .
•
[CD Upsampling]
Converts the music CD to a higher sampling
rate using sophisticated digital signal
processing for better sound quality.
•
•
•
to set the delay time.
Note
Allow 1ms setting for every 1 foot distance
between the speaker and the listening position.
[On] – Allows audio output through the
TV and the speaker system. If the audio
format on the disc is not supported, it
will be downmixed to two-channel sound
(linear-PCM).
[Off] – Disables audio output from the
TV. The sound is only output through the
speaker system.
[Off] – Disables CD-upsampling.
[88.2kHz (X2)] – Converts the sampling
rate of the CDs twice as high as the
original rate.
Note
CD upsampling is only available in stereo
mode.
Advertisement
Table of Contents
