Descaling Procedure - Philips Saeco PICOBARISTO SM3054 User Manual

English
20

Descaling procedure

START
DESCALING?
23 MIN
8 Place the container under the milk dispensing spout.
9 Press the MENU button and select MILK FROTH in the DRINKS menu to
start the carafe rinsing cycle.
10 Repeat step 9 until the milk carafe is empty.
Note: Never drink the solution dispensed during this step.
11 Repeat steps 6-10.
12 When the machine stops dispensing water, the cleaning cycle is finished.
13 Disassemble all the components and rinse them under a lukewarm tap.
The machine is ready for use.
When the display asks 'START DESCALING?', you need to descale the
machine. If you do not descale the machine when this message appears on
the display, the machine will eventually stop working properly. In this case,
repairs are not covered by the warranty.
Only use Philips Saeco descaling to descale the machine. Under no
circumstances should you use a descaler based on sulfuric acid,
hydrochloric acid, sulfamic or acetic acid (vinegar) as this may damage the
water circuit in your machine and not dissolve the limescale properly. Not
using the Philips descaler will void your warranty. Failure to descale the
appliance will also void your warranty. You can buy Philips Saeco descaling
solution in the online shop at www.saeco.com/care.
The descaling procedure lasts 23 minutes and consists of a descaling cycle
(20 minutes) and a rinsing cycle (3 minutes). You can pause the descaling or
rinsing cycle by pressing the ESC button. To continue the descaling or
rinsing cycle, press the OK button.
Note: Do not remove the brew group during the descaling procedure.
Warning: Do not drink the descaling solution or the water
dispensed during the descaling procedure.
1 Remove the drip tray and the coffee grounds container, empty and clean
them and put them back into place.
2 Place a large container (1.5 l) under the coffee dispensing spout.
3 When the display asks 'Start descaling?', press the OK button to start the
descaling procedure.
4 The display reminds you that you have to remove the AquaClean filter.
Remove the filter and press the OK button.
Note: You can press the escape button to skip descaling. If you want to
start the descaling procedure later, press the MENU button, select MENU
and scroll to select DESCALING. Press OK to confirm.
5 The display reminds you that you have to empty the drip tray. Press the
OK button to confirm.
6 The display reminds you that you have to insert the milk carafe. Fill the
milk carafe with water halfway, insert the carafe and open the milk
dispensing spout. Press the OK button to confirm.