Cisco N9K-C9332PQ Hardware Installation Manual page 18

Aci-mode switch
Hide thumbs Also See for N9K-C9332PQ:
Table of Contents

Advertisement

Planning for Power Requirements
The power supplies are rated to output up to 650 W (AC power supplies), but the switch requires less than
those amounts of power from the power supply. To operate the switch, you must provision enough power
from the power source to cover the requirements of both the switch and a power supply. Typically, this switch
and a power supply require about 228 W of power input from the power source, but you must provision as
much as 508 W power input from the power source to cover peak demand.
Note
Some of the power supply modules have rating capabilities that exceed the switch requirements. When
calculating your power requirements, use the switch requirements to determine the amount of power that is
required for the power supplies.
To minimize the possibility of circuit failure, make sure that each power-source circuit that is used by the
switch is dedicated to the switch.
Note
For AC input application, please refer to the following statement:
Warning
Statement 1005 Circuit Breaker
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that the
protective devices are rated not greater than 20A (North America), 16A (Europe), and 13A (UK).
Note
For DC input application, please refer to the following statement:
Warning
Statement 1005 Circuit Breaker
This product relies on the building's installation for short-circuit (overcurrent) protection.
• Ensure that the protective devices are rated not greater than 30A when the switch is powered with regular
DC power supplies (rated 48-60VDC).
• Ensure that the protective devices are rated not greater than 10A when the switch is powered with HVDC
power supplies (rated 240-350VDC).
Warning
Statement 1033
Connect the unit only to DC power source that complies with the Safety Extra-Low Voltage (SELV)
requirements in IEC 60950 based safety standards.
Note
We recommend 8-AWG wire for DC installations in the U.S.
Cisco Nexus 9332PQ ACI-Mode Switch Hardware Installation Guide
8
Preparing the Site

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nexus 9332pq

Table of Contents