Philips HD8834 User Manual page 80

ENGLISH
78
Machine actions
Coff ee is not brewed, is brewed
slowly or only a few drops are
brewed (see note).
Coff ee leaks out of the dispens-
ing spout.
No hot water is dispensed.
Frothed milk is too cold.
The milk is not frothed or will
not come out.
The descaling cycle cannot
be completed.
Causes
The coff ee grind is too fi ne.
The circuit is not primed.
The brew group is dirty.
The dispensing spout is dirty.
The machine circuit is clogged
by limescale.
The dispensing spout is clogged.
The circuit is not primed.
The machine circuit is clogged by
limescale.
The cups are cold.
The milk carafe is dirty or not
inserted correctly.
The carafe dispensing spout has not
been removed correctly.
The milk carafe is not fully
assembled.
The type of milk used is not suitable
for frothing.
The water dispensed for the rinse
cycle is not enough.
Note:
* These problems can be considered normal if the coff ee blend has been
changed or if the machine has just been installed. In this case wait until the
machine performs a self-adjusting operation as described in the "Saeco
Adapting System" chapter.
Solutions
Change coff ee blend or adjust grind-
ing as explained in the "Adjusting the
Ceramic Coff ee Grinder" chapter.
Prime the circuit (see the "Using the
Machine for the First Time" chapter).
Clean the brew group (see the "Weekly
Cleaning of the Brew Group" chapter).
Clean the dispensing spout and its
holes.
Descale the machine.
Clean the dispensing spout and its
holes.
Prime the circuit (see the "Using the
Machine for the First Time" chapter).
Descale the machine.
Preheat the cups with hot water.
Clean the carafe and insert it correctly.
Check that the milk dispensing spout
has been removed correctly.
Make sure that all components have
been correctly assembled.
Use the type of milk suggested in the
"Milk Carafe" chapter.
Press the on/off button and follow
the instructions described in the
"Interruption of the Descaling Cycle"
section.