Fan Power Connectors: CPUFAN, SYSFAN1, SYSFAN2
The fan power connectors support system coolng fan wth +12V. When connectng the
wre to the connectors, always note that the red wre s the postve and should be con-
nected to the +12V; the black wre s Ground and should be connected to GND. If the
manboard has a System Hardware Montor chpset on-board, you must use a specally
desgned fan wth speed sensor to take advantage of the CPU fan control.
CPUFAN/ SYSFAN1
Important
•
Please refer to the recommended CPU fans at processor's offical webste or consult
the vendors for proper CPU coolng fan.
•
CPUFAN supports fan control. You can nstall Control Center utlty that wll automat-
cally control the CPU fan speed accordng to the actual CPU temperature.
Fan cooler set wth 3 or 4 pns power connector are both avalable for CPUFAN.
•
Chasss Intruson Connector: JCI1
Ths connector connects to the chasss ntruson swtch cable. If the chasss s opened,
the chasss ntruson mechansm wll be actvated. The system wll record ths status
and show a warnng message on the screen. To clear the warnng, you must enter the
BIOS utlty and clear the record.
SYSFAN2
MS-7696
2-13