Table of Contents
Advertisement
Chapter 6. Troubleshooting
Other issue
The product smells like plastic.
The monitor appears tilted.
Audio or video cuts out intermittently.
Small particles are found on the edges of the product.
The
PIP
menu is not available.
When I try to change the PC resolution, a message
defined resolution is not
supported." appears.
There is no sound from the speakers in HDMI mode when
a DVI-HDMI cable is connected.
H DMI Black Level
is not functioning properly on an HDMI
device with YCbCr output.
There is no sound in HDMI mode.
In power saving mode, when the input source is
DisplayPort, PC display settings cannot be saved.
The plastic smell is normal and disappears over time.
Remove and then attach the stand again to the product.
Check the cable connection and connect it again if required.
Using a very hard or thick cable may corrupt audio and video files.
Make sure cables are flexible enough to ensure durability. When mounting the product onto a wall, it is
recommended to use right-angle cables.
The particles are part of the product design. The product is not defective.
The menu is enabled or disabled depending on the
"The
The message
"The defined resolution is not
maximum resolution of the display.
To resolve the issue, change the PC resolution to a resolution supported on the display.
DVI cables do not transmit sound data.
Make sure to connect the audio cable to the correct input jack to enable audio.
This function is available only when a source device, such as a DVD player and STB, is connected to
the product via an HDMI (RGB signal) cable.
Displayed picture colors may not look normal. Video or sound may not be available. This can occur if a source device
that only supports an older version of the HDMI standard is connected to the product.
If these issues occur, connect an audio cable along with the HDMI cable.
Some PC graphics cards may not automatically recognize HDMI signals that do not include sound.
In this case, manually select a sound input.
PC
DVI PC
Go to
System
→
Power Control
settings again. Ensure the set is turned on.
Source
mode.
supported." appears if the input source resolution exceeds the
Sound input
Auto
Audio In (Stereo ports)
and set
Max. Power Saving
to Off. Alternatively, configure the PC display output
81
Screen mode
PC settings
PC settings
Advertisement
Table of Contents
