TP-Link Archer VR200v User Manual page 9

Chapter 1
Name
Power
DSL
Internet
Wireless 2.4GHz
Wireless 5GHz
LAN
USB
VoIP
Note:
1. If the DSL LED is off, check your internet connection first. Refer to
about how to make internet connection correctly. If you have already made a right connection, contact your ISP
to make sure your internet service is available now.
2. If the internet LED is off, check your DSL LED first. If your DSL LED is also off, please refer to
is ON, check your internet configuration. You may need to check this part of information with your ISP and make
sure everything have been input correctly.
Status
On System initialization is complete.
The system is initializing or the firmware is being upgraded.
Flashing
Do not disconnect or power off the modem router.
Power is off. Please ensure that the power adapter is
Off
connected correctly.
On DSL synchronization is established.
Flashing DSL synchronization is in progress.
DSL synchronization failed. Please refer to
Off
troubleshooting.
On The network is available with a successful internet connection.
No successful internet connection is available, or the modem
Off router is operating in Bridge mode. Please refer to
troubleshooting.
On The wireless 2.4GHz band is working properly.
Flashing WPS is in process and will continue for about 2 minutes.
Off The wireless 2.4GHz band is disabled.
On The wireless 5GHz band is working properly.
Flashing WPS is in process and will continue for about 2 minutes.
Off The wireless 5GHz band is disabled.
On At least one LAN port is connected.
Off No LAN port is connected.
On USB device is identified.
Flashing USB device identification is in progress.
Off USB device is unplugged or identification failed.
On The analog phone is off-hook or the cordless phone is busy.
Flashing The phone is ringing or the cordless phone is registering.
Off The phone is on-hook.
Get to Know Your Modem Router
Indication
Connect Your Modem Router
Note
for
Note 1
for
Note 2
for more information
1. If your DSL LED
4