Table of Contents
Advertisement
•
Audio Surrond L + R :
2 Vrms (> 1 kohm)
•
Audio Center : 2 Vrms (> 1 kohm)
•
Audio Subwoofer :
1.15 Vrms (> 1 kohm)
•
Audio Rear L + R: 2 Vrms (> 1 kohm)
•
Digital output: 0.5 Vp-p (75 ohm)
•
Optical, Coaxial
•
HDMI output
•
Sampling frequency:
•
MP3: 32 kHz, 44.1 kHz, 48 kHz
•
WMA: 44.1 kHz, 48 kHz
•
Constant bit rate:
•
MP3: 112 kbps - 320 kpbs
•
WMA: 48 kpbs - 192 kpbs
USB
•
Compatibility: Hi-Speed USB (2.0)
•
Class support: USB Mass Storage Class
•
File system: FAT16, FAT32, NTFS
•
USB port: 5V
, 500mA (for each port)
•
Support HDD (a portable hard disc drive):
an external power source may be needed.
Main unit
•
Power supply rating: AC 220-240V~, 50 Hz
•
Power consumption: 30 W
•
Power consumption in standby mode (fast
wakeup disabled): < 0.16 W
•
Dimensions (w x h x d):
435 x 90 x 268 (mm)
•
Net Weight: 3.98 kg
Accessories supplied
•
Remote control and batteries
•
AC power cable
•
User manual
Laser Specification
•
Laser Type (Diode): AlGaInN (BD), AlGaInP
(DVD/CD)
•
Wave length: 398 ~ 412nm (BD),
650 ~ 664nm (DVD), 784 ~ 796nm (CD)
•
Output power (Max ratings): 20mW (BD),
7mW (DVD), 7mW (CD)
6 Troubleshooting
Warning
•
Risk of electric shock. Never remove the casing of the
player.
To keep the warranty valid, never try to repair
the player yourself.
If you have problems using this player, check the
following points before you request service. If
you still have a problem, register your player and
get support at www.philips.com/support.
If you contact Philips, you will be asked for the
model and serial number of this player. The
model number and serial number are on the
back of this player. Write the numbers here:
Model No. __________________________
Serial No. ___________________________
Main unit
The buttons on this player do not work.
•
Disconnect this player from the power supply
for a few minutes, and then reconnect.
Picture
No picture.
•
Make sure that the TV is switched to the
correct source input for this player.
For the composite connection (via the VIDEO
•
connector) to the TV, on this player select a
video resolution of 480i/576i or 480p/576p
to enable video output (press , and select
[Setup] > [Video] > [HDMI video]) .
No picture on HDMI connection.
•
Make sure that the HDMI cable is not
faulty. If it is faulty, replace with a new
HDMI cable.
•
On the remote control, press
press "731" (numeric buttons) to recover
picture display. Or wait for 10 seconds for
auto recovery.
and then
EN
21
Advertisement
Table of Contents
