U-Line UCWC518 User Manual & Service Manual page 21

USER GUIDE
3. Remove evaporator cover.
a. Remove thermistor cover - use a flat tool to pry out
the push pin fastener
b. Remove 8 screws (3 on each side 2 on top)
3-b
3-a
c. Carefully pull evaporator cover out far enough to
disconnect evaporator fan from behind cover
d. Remove evaporator cover - take care to slide
thermistor through notch in evaporator cover
4. Remove evaporator fan assembly from evaporator
cover.*
Cleaning
5. Remove 4 rack supports by removing 4 screws on each
one.
3-a
6. Remove screws and spacers from evaporator and
carefully pull evaporator forward - just enough to be
able to wipe both surfaces of the evaporator and the
back wall.
7. Thoroughly clean and sanitize all removed components
including all hardware.
*Note: Carefully clean and sanitize the fan
blades, but DO NOT submerse fan.
8. Re-install all components by reversing above steps
1 - 6.
21
u-line.com