U-Line UCWC518 User Manual & Service Manual page 20

USER GUIDE
INTERIOR CLEANING & SANITIZING
NOTICE
Do not use any solvent-based or abrasive
cleaners. These types of cleaners may transfer taste
and/or odor to the interior products and damage or
discolor the interior.
Remove Slide-out Metal Shelf
1. Remove all items from shelf.
2. Pull shelf out far enough to firmly grasp both sides.
Lift front end slightly (about 1/4") to center the pin in
the slot.
3. Pull shelf towards you until all pins are clear of the
slots.
4. Slightly tilt one side. Gently pull shelf towards you to
remove from unit.
Note: Take care when removing shelf to avoid
scratching interior of unit.
5. Once removed, retract the slides.*
6. Thoroughly clean and sanitize shelf and slides.
7. Re-install shelf by reversing above steps 1 - 4.
Cleaning
Remove Wine Rack
1. Fully extend empty rack
2. Firmly grasp both sides of rack and lift front end of
rack slightly (about 1/4") to center the pin in the slot.
3. Pull rack towards you until all pins are clear of the
Center
slots. If only repositioning the rack, do not remove
the pin
completely - go to "Rack Installation" Step 2.
4. Slightly tilt one side. Gently pull rack towards you to
remove rack from unit.
Note: Take care when removing rack to avoid
scratching interior of unit.
5. Once removed, retract the slides.
6. Thoroughly clean and sanitize storage wine rack and
slides.
7. Re-install storage bin and slides by reversing above
steps 1 - 4.
*Note: The slides on the rack have a thin coating which is used to
block moisture and provide lubrication. Use care when handling.
Evaporator Components and Rack Supports
1. Disconnect power to the unit.
2. Fully defrost unit (See DEFROSTING)
20
u-line.com
Center
the pin
Ce
Ce
th
the