System Bios; Power Supply - Acer Veriton M490G Service Manual

2 reserved 2pin GPIO connector
•
1 Serial port header (COM2) (near rear IO is preferable)
•
1 TPM DB header (2x10) (*check Acer's TPM DB spec) (Refer to Appendix)
•
1 2pin Intrusion Alarm connector
•
1 LPT 2*13pin header (near rear IO is preferable)
•
1 2*4 pin internal speaker header
•
Color management for on board connecter (please refer to Acer spec)
•
Header Naming should follow MB Header Naming (Refer to Appendix)
•
Braidwood connector (reserved)
•
1 3pin ME enable/disable connector (with 1 jumper)
•

System BIOS

Size: 64Mb
•
AMI Kernel with Acer skin/copyright
•

Power supply

300W/ in stable mode (Acer/GTW Assign System Power Unit)
•
Design for Intel Piketon chipset compatible system
•
Voltage design should be covered +5V, +3.3V, +12V, +5VSB, -12V (attention to 12V output capability)
•
Demand for both PFC/Non-PFC solutions (two different quotations are needed)
•
Active PFC with Energy Star 5.0
•
EuP lot6 requirements
•
4 Chapter 1