Bernina 380 Manual page 14

Preparation - Sewing
12
Winding a Bobbin
Inserting a Bobbin
turn power switch on (to «I»)
█
place empty bobbin on spindle
█
place thread on spool pin
█
attach appropriate spool disc; diameter of thread spool determines disc size
█
following the direction of the arrow take thread through the rear guide and
█
round the pre-tension stud
wind the thread two to three times around the empty bobbin and cut off any
█
excess thread on the thread cutter
push engaging lever against bobbin, the winder works automatically
█
the motor will stop automatically when the bobbin is full
█
Thread cutter
pull thread over thread cutter when removing the bobbin
█
Bobbin winding while sewing
place thread spool on vertical spool pin then, following the direction of the
█
arrow, take thread through the thread guide and around the pre-tension
stud
then proceed as mentioned above
█
Insert the bobbin so that the thread runs clockwise.
Laying the thread into the slot
Pull the thread counter clockwise into the slot.
Pulling the thread under the spring
Pull the thread to the left under the spring until it lies in the T-shaped slit at the
end of the spring. The bobbin must turn clockwise.
033301.71.04_2014-02_Manual_B330_B350_PE_B380_EN