Bosch WAXH2KOLSN User Manual And Installation Instructions page 59

Fault
"E:35 / -10"
⁠
⁠
⁠ lights up.
⁠ flashes.
All other error codes.
The appliance is not
working.
Cause and troubleshooting
Call the after-sales service.
▶
→ "Customer Service", Page 70
The detergent drawer has not been pushed in as far
as it can go.
Push the detergent drawer in as far as it will go.
▶
The pump unit is not inserted.
Insert the pump unit into the detergent drawer.
1.
→ "Cleaning the detergent drawer", Page 49
Push the detergent drawer in as far as it will go.
2.
Detergent dosage is too high.
Immediate measure: Mix one tablespoon of fabric
▶
softener with 0.5 litres of water and pour the mix-
ture into the compartment for manual dosing (not
for outdoor clothing, sportswear or items stuffed
with down).
If intelligent dosing is activated, reduce the basic
▶
dosage → Page 43.
If you dose manually, reduce the amount of deter-
▶
gent for the next washing cycle with the same load.
The temperature is too high.
Wait until the temperature has dropped.
▶
→ "Cancelling the programme", Page 40
▶
Water level is too high.
Start the Drain programme.
▶
Laundry is caught in the door.
Open the door again.
1.
Remove any trapped laundry.
2.
Close the door.
3.
Press ⁠ to start the programme.
4.
Door is not closed.
Close the door.
1.
Press ⁠ to start the programme.
2.
Malfunction
Call the after-sales service.
▶
→ "Customer Service", Page 70
The mains plug of the power cord is not plugged in.
Connect the appliance to the power supply.
▶
The circuit breaker is faulty.
Check the circuit breaker in the fuse box.
▶
Troubleshooting en
59