Table of Contents
Advertisement
8.
Plug in table saw, turn it ON, and use a push
stick or push block to feed workpiece through
blade, using a slow and steady feed rate.
Note: We recommend making a series of
light cuts that get progressively deeper, to
reduce the chance of stalling the motor.
9.
Flip workpiece end-for-end, keeping same
side against fence, and run workpiece through
blade.
10. Repeat Steps 7–9 until blade is close to half
the height of board to be resawn. The ideal
completed resaw cut will leave a
tion when resawing is complete as shown in
Figure 78 on Page 48. Leaving a
tion will reduce risk of kickback.
11. Turn OFF table saw, then separate parts of
workpiece and hand plane remaining ridge to
remove it.
12. When finished resawing, remove resaw bar-
rier and auxiliary fence, then re-install blade
guard/spreader or riving knife and standard
table insert.
Model G0899 (Mfd. Since 10/20)
The danger of kickback increases relative to
the depth of a cut. Reduce the risk of kick-
back by making multiple passes to achieve
the desired depth of cut. Failure to follow
these warnings could result in serious per-
sonal injury.
Always use push sticks or push paddles to
increase safety and control during opera-
tions which require that the blade guard
⁄
" connec-
1
8
and spreader must be removed from the
saw. ALWAYS replace blade guard after
⁄
" connec-
1
8
resawing is complete.
-49-
Advertisement
Table of Contents
