Grizzly G0899 Owner's Manual page 26

10. Attach front rail to extension wings with (2)
M10-1.5 x 35 hex bolts, (4) 10mm flat wash-
ers, (2) 10mm lock washers, and (2) M10-
1.5 hex nuts as shown in Figure 23. Finger
tighten fasteners.
Figure 23. Front rail attached to extension
wings.
11. Make sure top of rail is parallel with table top,
then tighten fasteners installed in Steps 9 &
10.
12. Install front rail tube onto front rail with (5)
20 x ⁄ hex bolts, 6mm flat washers, and 6mm
5
8
lock washers, as shown in Figure 24. Finger-
tighten fasteners.
Front Rail Tube
x 5
Figure 24. Front rail tube attached to front rail.
13. While standing at front of table, pull rail tube
toward you as far as possible, then tighten
fasteners installed in Step 12. This will help
make sure there is enough room for fence to
slide.
-24-
x 2
⁄ -
1
4
14. Attach rear rail to main table using (2) M10-
1.5 x 25 hex bolts, 10mm lock washers, and
10mm flat washers, as shown in Figure 25.
Check to make sure rear rail is parallel to
table and below miter slots before completely
tightening hex bolts.
15. Secure rear rail to extension wings with (2)
M10-1.5 x 35 hex bolts, (4) 10mm flat wash-
ers, (2) 10mm lock washers, and (2) M10-1.5
hex nuts (see Figure 25).
Rear Rail
x 2
x 2
Figure 25. Rear rail installed.
16. Attach switch to bottom left-hand side of front
rail using (2) M6-1 x 15 flat head screws,
6mm lock washers, 6mm flat washers, and
M6-1 hex nuts, as shown in Figure 26.
Figure 26. Switch installed.
Model G0899 (Mfd. Since 10/20)
x 2