Table of Contents
Advertisement
Section 2 - OPERATING INSTRUCTIONS
2.1 PRE-START CHECK LIST
Make the following checks and perform the service
required before each start-up.
2.1.1. Check tires and add or release air as needed
to bring pressure to 12 psi in front and 12 psi in rear
tires.
2.1.2. Check guards, deflectors and covers to make
sure all are in place and securely tightened.
2.1.3. Check engine oil and add oil as needed to
bring level up to the FULL mark. Refer to engine
owner's manual for oil specifications. See Figure 2.1.
ENGINE OIL DIPSTICK
FIGURE 2.1
2.1.4. Check Blade switch to insure it works freely.
Switch is pulled "OUT" into the "ON" position for
blade engagement or pushed back "IN" into the
"OFF" position for blade disengagement. See
Figure 2.2. IMPORTANT: Disengagement stops the
blades rotation.
PULL "OUT" TO
ENGAGE
PUSH "IN" TO
DISENGAGE
FIGURE 2.2
SAFE LEVEL
AREA
BLADE
SWITCH
6
2.1.5. Clean exterior surfaces of cutting deck and
engine of any accumulation of dirt, grass, oil, etc.
Keep engine air intake screen and cooling fins clear
at all times.
2.1.6. Add fuel to tank of the YARD CRUISER
outside where fumes can safely dissipate. Make
sure fuel filler cap is tight and vent is open after
refueling. See Figure 2.3. Refer to engine owner's
manual for fuel specifications.
FUEL
FILLER
CAP
FUEL
TANK
FIGURE 2.3
IMPORTANT: This YARD CRUISER is equipped with
hydrostatic drive. The forward, rearward and steering
movement of the machine is controlled by a joystick
lever. Joystick operations should be performed only
from the operator's position in the seat. A small
movement of the joystick can cause the machine to
move instantly. Move joystick very carefully and slowly.
1. Always move the joystick to the center position to
"STOP" machine. IMPORTANT: To stop machine
always return the joystick with hand assistance to the
neutral position. Always engage parking brake when
leaving operator's seat.
2. Move the joystick forward to propel the machine
forward.
3. Move the joystick rearward to propel the machine
backward.
4. Move the joystick to the right to rotate the front of
the machine in circular motion to the right, as in turning
around to go in a different direction.
5. Move the joystick to the left to rotate the front of the
machine in circular motion to the left, as in turning
around to go in a different direction.
OPEN
VENT
Advertisement
Table of Contents
