Table of Contents
Advertisement
How to Change Management IP Address for Existing Ethernet Port
Users can use the following command to change management IP address for existing Ethernet port. The
commands are listed as below.
Command
$modify aggr intf ifname aggr-0 ip
<new-ip> mask <new-mask>
$modify ethernet intf ifname eth-* ip
<new-ip> mask <new-mask>
How to Create more VC/EOA/Bridge
Users can use the following command to create more VC/EOA/Bridge. The commands are listed as
below.
Command
$create atm vc intf ifname aal5-* vpi
<vpi> vci <vci> lowif atm-*
[vcmux/llcmux] [fast/interleaved]
$create eoa intf ifname eoa-* lowif
aal5-*
$create bridge port intf portid
<bridge-port-id> ifname eoa-*
How to Setup SNMP Community/Host/Trap
Users can use the following command to setup SNMP community/host/trap. The commands are listed as
below.
Command
$create snmp comm community <community>
<RW|RO>
$create snmp host ip <host-ip>
community <community>
$create snmp traphost ip <host-ip>
community <community>
How to Create VLAN
Users can use the following command to create VLAN. The commands are listed as below.
Command
$create vlan static vlanname
<vlan-name> valnid <vlan-id>
[egressports <bridge ports>]
Quick Start Guide for VigorAccess
Description
Aggregation Ethernet
Non-Aggregation Ethernet
(*: 0 or 1)
Description
(*:0 ~ 23 is used for atm; 0~191 is used for aal5)
(*:0~191 is used for aal5 and eoa)
(*:0~191 is used for eoa,; 1~192 is used for
<bridge-port-id>)
Description
Create SNMP community
Create a host to manage the device through SNMP
Create a host to capture the traps.
Description
Create VLAN
11
Advertisement
Table of Contents
