Table of Contents
Advertisement
P
a
r
t
I
I
:
P
a
r
t
I
I
:
Here provides some general and common commands used in IP DSLAM for users to configure the IP DSLAM
DSL Module.
Note: Please refer to the Command Line Interface manual for getting more commands that IP DSLAM
supports. Contact your dealer for advanced information.
How to Monitor DSL Status
Users can use the following command to check the status for specified DSL port. The commands are listed
as below.
Command
$get adsl atuc physical ifname dsl-*
$get adsl atur physical ifname dsl-*
How to Enable/Disable a DSL Port
Users can use the following command to enable or disable DSL port for certain user. The commands are
listed as below.
Command
$modify adsl line intf ifname dsl-*
enable
$modify adsl line intf ifname dsl-*
disable
How to Read DSL Training Rate
Users can use the following command to read DSL Training Rate for specified DSL port. The commands
are listed as below.
Command
$get adsl atuc channel ifname dsli-*
$get adsl atur channel ifname dslf-*
$get adsl atuc channel ifname dsli-*
$get adsl atur channel ifname dslf-*
How to Change ADSL Line Profile
Users can use the following command to change the ADSL Line Profile for specified DSL port. The
commands are listed as below.
Command
$modify adsl line intf ifname dsl-*
disable
$modify adsl line profile ifname dsl-* ?
$modify adsl line intf ifname dsl-*
enable
Quick Start Guide for VigorAccess
Description
for downstream (*: 0 ~ 23)
for upstream (*: 0 ~ 23)
Description
Enable
(*: 0 ~ 23)
Disable
(*: 0 ~ 23)
Description
for downstream/interleave channel (*: 0 ~ 23)
for upstream/fast channel
for downstream/interleave channel (*: 0 ~ 23)
for upstream/fast channel
Description
Disable
(*: 0 ~ 23)
(*: 0 ~ 23, ?: means to get more information)
Enable
(*: 0 ~ 23)
(*: 0 ~ 23)
(*: 0 ~ 23)
9
Advertisement
Table of Contents
