Table of Contents
Advertisement
Answering system settings
Call screening
While a caller is leaving a message, you can
listen to the call through the handset's
speaker. To adjust the speaker volume, press
MDN or MCN repeatedly. You can answer the call
by pressing M
N on the handset. Call
screening can be set for each handset. The
default setting is "On".
1
M
N#310
2
MbN: Select the desired setting. a MOKN
a M
N
Number of rings before the unit
answers a call
You can change the "Number of Rings"
before the unit answers a call. You can select
2 to 9 rings, or "Auto".
The default setting is "5 Rings".
"Auto": The unit's answering system answers
at the end of the 2nd ring when new
messages have been recorded, or at the end
of the 5th ring when there are no new
messages. If you call your phone from outside
to listen to new messages (page 32), you
know that there are no new messages when
the phone rings for the 3rd time. You can then
hang up without being charged for the call.
1
M
N#211
2
MbN: Select the desired setting. a MOKN
a M
N
For voice mail service subscribers
To receive voice mail and use answering
system properly, please note the following:
R To use the voice mail service (page 34)
provided by your service provider/telephone
company rather than the unit's answering
system, turn off the answering system
(page 30).
R To use this unit's answering system rather
than the voice mail service provided by
your service provider/telephone company,
Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333
TGC310_320E(en)_1222_ver002.pdf
please contact your service provider/
telephone company to deactivate your
voice mail service.
If your service provider/telephone company
cannot do this:
– Set this unit's "Number of Rings"
– Change the number of rings of the voice
Caller's recording time
You can change the maximum message
recording time allowed for each caller. The
default setting is "3 Minutes".
1
M
2
MbN: Select the desired setting. a MOKN
a M
Selecting "Greeting Only"
You can select "Greeting Only" which sets
the unit to announce a greeting message to
callers but not record messages.
Select "Greeting Only" in step 2 on
"Caller's recording time", page 33.
Note:
R When you select "Greeting Only":
– If you do not record your own message,
– If you use your own message, record the
33
Answering System
setting so that this unit's answering
system answers calls before the voice
mail service of your service provider/
telephone company does. It is necessary
to check the number of rings required to
activate the voice mail service provided
by your service provider/telephone
company before changing this setting.
mail service so that the answering
system can answer the call first. To do
so, contact your service provider/
telephone company.
N#305
N
the unit will play the pre-recorded
greeting-only message asking callers to
call again later.
greeting-only message asking callers to
call again later (page 30).
2014/12/22
11:04:36
33
Advertisement
Table of Contents
