Table of Contents
Advertisement
Problem
Caller information is slow
to display.
Time on the unit has
shifted.
The name stored in the
phonebook is not fully
displayed while an outside
call is being received.
Answering system
Problem
The unit does not record
new messages.
I cannot operate the
answering system
remotely.
The unit does not emit the
specified number of rings.
Liquid damage
Problem
Liquid or other form of
moisture has entered the
handset/base unit.
Caution:
R To avoid permanent damage, do not use a microwave oven to speed up the drying process.
Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333
TGC310_320E(en)_1222_ver002.pdf
Cause/solution
R Depending on your service provider/telephone company, the
unit may display the caller's information at the 2nd ring or later.
Set the first ring to "Off" (page 22).
R Move closer to the base unit.
R Incorrect time information from incoming Caller ID changes the
time. Set the time adjustment to "Manual" (off) (page 22).
R Edit the phonebook entry name to fit in 1 line of text (page 19).
Cause/solution
R The answering system is turned off. Turn it on (page 30).
R The message memory is full. Erase unwanted messages
(page 31).
R The recording time is set to "Greeting Only". Change the
setting (page 33).
R Your service provider/telephone company's voice mail service
may be answering your calls before the unit's answering
system can answer your calls. Change the unit's number of
rings setting (page 33) to a lower value, or contact your service
provider/telephone company.
R The remote access code is not set. Set the remote access
code (page 32).
R You are entering the wrong remote access code. If you have
forgotten your remote access code, enter the remote access
code setting to check your current code (page 32).
R The answering system is turned off. Turn it on (page 32).
R If the first ring is turned off, the number of rings decreases by 1
from the specified number of rings.
Cause/solution
R Disconnect the AC adaptor and telephone line cord from the
base unit. Remove the batteries from the handset and leave to
dry for at least 3 days. After the handset/base unit are
completely dry, reconnect the AC adaptor and telephone line
cord. Insert the batteries and charge fully before use. If the unit
does not work properly, contact an authorised service centre.
39
Useful Information
2014/12/22
11:04:36
39
Advertisement
Table of Contents
