Denon AVR-5805 Supplementary Manual page 3
Avr/avc control protocol
Hide thumbs
Also See for AVR-5805:
- Operating instructions manual (208 pages) ,
- Manual (8 pages) ,
- Service bulletin (7 pages)
Advertisement
NETWORK SETUP of AVR-5805/AVC-A1XV
>Procedure of Network Setup mode.
(1)Push the POWER switch during STANDARD button and 9CH STEREO button press simultaneously.
(2)Press SYSTEM SETUP button, then System Setup Menu appears on FL-display(and OSD)
(3)Select Option Setup and select Network Setup.
(4)Set parameters described below.
<DHCP>
"ON"---Use this setting when DHCP server is on the local network.
"OFF"---Use this setting when DHCP server is not on the local network.
<IP Address>
When <DHCP> sets "OFF", please set IP address.
When <DHCP> sets "ON", you can confirm the IP address that is set by server.
<Subnet Mask> When <DHCP> sets "OFF", please set Subnet Mask.
When <DHCP> sets "ON", you can confirm the Subnet Mask that is set by server.
<Gateway>
Set the address of Gateway when Gateway is on the local network.
Do not set this parameter when Gateway is not on the local network.
<Primary DNS> Do not set this parameter.
<Second DNS>
Do not set this parameter.
<Proxy>
Set this parameter "OFF".
<Network Option:Standby Mode Power Saving>
"OFF"---Use this setting when using the AVR-5805/AVC-A1XV connected in a network.
"ON"--- Use this setting when not using the AVR-5805/AVC-A1XV connected in a network.
This setting is reducing the power consumption in the standby mode.
3/25
29.Mar.06
Advertisement
